Shown here is a standard crossover toolbox with a single lid. This box is available in a double lid , or"gull wing" lid style.

These boxes are "topsider" toolboxes. They come in several sizes, and mount directly to the truck's side rails. This truck also has a set of ladder racks added. We made the rear rack removable.

This is a chest style box, which is mounted under the tonneau cover. We made it easily removable with 2 bolts.

Another set of topsider boxes on the job.

These "inner-side boxes" sit a little differently than the topsiders, and match up to the crossover box nicely.

Here's a 24" wide underbody box on a mason dump truck. This style box comes in 24", 36" & 48" lengths. There's no other way to gain storage space on this type of truck.

We installed these huge underbody boxes on this moving van. It took a little effort to fit this much toolbox. We had to notch the body to raise the boxes as high as possible...

...but it was worth the effort. Now the movers can carry even more cargo and supplies.

Here's a 36" wide underbody box with it's big mouth open.

Here's a special job that required this topsider box be notched and welded to fit a particular construction vehicle. The white line is the where the box will be cut.

This shows the top corner of the box already cut off where it was marked. A piece of aluminum has been prepared to fit right in this spot.

The finished box is ready to be mounted and put into service. This type of specialty work is what we live for, and we have the resources to provide sensible results to your equipment challenges.